Often used in mass produced lighting, this part is available as a replacement to an existing broken lampholder of the same specification. The terminals are 'push in' which means that once the wire has been pushed in it is not recommended (and difficult) to release. However if the existing lampholder base is fixed in place, this is a good option because the top part should be compatible with the existing base, if it is the same snap together specification.  Fits a 30mm shade hole

2 Part Lampholder

Takes 1 x SES / E14 Lamp

For use on 10mm male threaded tube

Shade Compatible (Lock Ring Not Included)

Width: 27mm, Height: 55mm